Baxi Potterton Boiler Spezifikationen PDF herunterladen (Seite 30)

Replacement of Parts - Page 30

Fig 19

5.12 Central Heating and Boiler Switches

1. Remove the white front case and base panel.

See 4.1 & 4.2 in ‘Routine Maintenance’.

Lower the facia panel, (1 screw).

2. Make note of the wire routing and switch orientation and

disconnect the molex plug from the electronic control

board.

3. Using a small screwdriver press the retaining lugs on the

switch body sides inwards and remove the switch from

the control panel. Withdraw the switch and leads and

feed the molex plug through the cut out in the panel

4. Fit new switch assembly and re-assemble in reverse

order. Ensure that the switch is the correct way round in

the panel i.e. when the Stand-by/On switch is On, the

red indicator line on the switch can be seen.

5. Re-fit the molex plug to the correct plug position on the

electronic control board.

5.13 Control Boards

The electronic control assembly is in three parts:

• The User Display Board.

• The Control Board.

• The Full Sequence Control Board.

1. Remove the white front case and base panel.

See 4.1 & 4.2 in ‘Routine Maintenance’.

(i) USER DISPLAY BOARD

1. Undo the fixing screw retaining the facia panel and

swing the panel downwards.

2. Remove the plug connector/s from the rear of the board

and undo the four securing screws.

3. Replace board and re-assemble in reverse order.

(ii) MODULATION CONTROL BOARD

Note: The board has a replaceable fuse rated at 2A.

1. Undo the fixing screw retaining the facia panel and

swing the panel downwards.

2. Remove the plug connectors on the larger control board

and undo the four securing screws.

3. Replace the board and re-assemble in reverse order.

4. Reset the C.H. range rate - see Section 3.3.(11).

(iii) FULL SEQUENCE CONTROL BOARD

1. Undo the fixing screw retaining the control panel

assembly (top right hand side of control box) and swing

the control assembly downwards.

2. Remove the cover over the full sequence control (two

screws).

3. Slide the electrode and flame sensors wire connections

out of their respective slots on the board. Disconnect all

plug connections and carefully remove the earth tab.

4. At each of the four standoff pillars, push the small barb

inwards and lift the board free.

5. Replace the board and re-assemble in reverse order.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 46 47

Kommentare zu diesen Handbüchern

Keine Kommentare

Baxi Potterton Boiler Spezifikationen Seite 30

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Warmwasserbereiter & Kessel Baxi Potterton Boiler